![]() ![]() Youtube of the tool change, sorry the air compressor is so loud. Have to slow way down to catch angle data from CSMIO-ENC - GetInput(84). Youtube of ATC dry run with spindle orienting. I ended up using a macro to read the ENC angle value to orient it manually. ![]() My ENC firmware version = 1.02 I was curious how that gets updated? When you update the CSMIO/IP? I see no separate firmware downloads for ENC on CS website. I haven't made any changes to my spindle settings. The diagnostics shows it was sending a signal, but no change on the vfd, spindle speed, or machs rpm reading. I am sure the encoder is fine and wired correct because the ENC plugin monitor shows correct angle movements and correct RPMs.Īsked CS-Labs how to tune the PID on monday and still no response. I would tell the spindle to go to 12000 rpm and it would stay idle at the min 7200 rpm.I couldn't get my relays to work so I just hit start on the vfd and then mach takes over. I put those settings in the PID settings for the CSMIO plugin/spindle section and the spindle just revs up to very high speeds when it should be 0 RPM. I moved the spindle encoder to an axis encoder input, configured it as an Axis and it did autotuning the PID. I could not get the CSMIO-ENC option to "Align at stop" to work.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |